Maintenance of motorized spindle

2005-11-21 08:49:14 electric spindle

The operator shall use the vacuum cleaner to clean the debris on the rotor end and the wiring terminal after daily work, so as to prevent debris accumulation and avoid the debris entering the bearing and leading to the wear of the high-speed bearing.  

When the cutter is changed, the operator must unscrew the nut. The cutter can not be changed by directly inserting the cutter.

The operator must check the working state of the cooling water flow of the electric spindle, check whether the pump is working normally, check whether the cooling water is polluted by scale and microorganism, check whether the pipeline is normal. 


0086 51985112317